The best way to Use Fiber-Board to Install Floor Tile

Tile can enhance the look of bathroom nearly any kitchen or entry-way. This tough materials comes in styles, dimensions, several colors and finishes making it simple to match your decor. It is even simple to sustain, because it is impervious to water, resists stains and dirt, and needs little more treatment than routine cleansing. A floor using a wood sub-floor needs the addition of a cement-fiber underlayment or backer board, although tile may be laid on a floor. Cement fiber board is just what its title suggests — a board made with a few type of fiber embedded for extra power from Portland cement.

Inspect the strand board or wood flooring that is alternative for other issues or just about any nails. Eliminate particles or any building dirt using a shopvac when it’s a sub-floor. Remove alternative material or any outdated flooring paste.

Locate areas or any spots where the ground is not level, using a level onto it using the help of a 4 foot level or a longboard. Level it, if required, with self-leveling cement and let it dry completely before continuing.

Measure the area using a tape measure and around attract a program to install backer board with as several sheets that are complete as feasible, with seams staggered therefore joints don’t align over the area, and without four-corner intersections.

Lay out the sheets to “dry suit” them on the ground and mark places that need to be cut at corners, around cupboards and other hurdles. Leave a gap of inch between fiber board sheets 1/8 at least 1/4 inch along

Cut the backer board to to suit corners or or about hurdles utilizing a dry wall observed or jig saw. Some fiber-board may be cutin straight lines snapping it against an extended straight-edge and by scoring it having a knife. Test- match the items and set them a side in the correct purchase to be installed, toward a do-or and usually functioning from walls.

Spread thin-set mortar using the notched fringe of of a trowel within the subfloor. Comb the thin set with ridges allin the sam-e path. Cover a location somewhat bigger compared to first bit of board and lay it in location.

Drive screws using a screw gun every 6″ over the face-to secure it to the sub-flooring round the perimeter of the board and every 8″. Drive screw heads somewhat below the the top of board.

Fill the screw-head holes with thin set mortar that is extra and lay fiber glass mesh tape on the joints between boards, fixed with thin-set. This this system is comparable to filling and taping dry wall joints.

Add another board abutting the one and fasten it in the same manner. Keep incorporating individually to boards before the whole flooring is coated. Put mesh tape and secure it with thin-set mortar.

See related